It’s all in the planning
When it comes to bathroom design, small can still be beautiful – specifically if you plan the project in advance. Think about your required layout so that you can observe how it’ll operate in practice so when you speak to your builder you will have a wise decision of the items you would like. To help you begin planning, the Builders In Kent has published The fundamental Guide to Do it yourself, a free brochure full of sound suggestions about planning do it yourself projects, and selecting and working with your builder.
Use the skills
Adding a bathroom by converting an existing room or building an extension is a job for an expert builder or plumber. You won’t save money by doing the work yourself if you end up with water gushing through the ceiling below!
Regulations
Unless you are building extra time, you won’t need planning permission for a new bathroom, but when you’re converting a room from scratch you may want to satisfy Building Regulations so get in touch with your building control department at the local council for advice.
Are you able to take the pressure?
If you’re adding another shower or bath, you may need an additional storage tank or pressure pump to prevent water pressure fluctuating. To provide sufficient pressure to operate a shower you’ll either have to install a pump or enhance the height of the cold water storage tank.
The benefit of instant hot water from a combination boiler ought to be weighed against the drawback to possible lower warm water pressure than that achieved with a warm water tank system.
Don’t get lost in space
If you are upgrading a current bathroom on a budget, you should look at putting new sanitary ware in the same place as before, as re-plumbing will add towards the cost. A brand new layout may be a better utilization of space, so begin by measuring the area and thinking about paper the best position of the bath, basin and loo.
For those who have a separate loo and bathroom you might want combine the two rooms. You may be surprised at the quantity of dead space which is wasted in a separate toilet This could also provide you with necessary light.
Waste not want not – Get green!
The primary practical consideration in a bathroom is getting eliminate waste water, so it’s normally cheaper to put the bathroom at the rear of the house where it is simpler to operate a soil pipe.
Did you know that over 30% of water delivered to the home is employed for flushing the loo? The most recent cisterns use 2 litres less water per flush than ones fitted before 1993.
Most showers tend to be more water and fuel-efficient in contrast to baths – the exception being powershowers. These use a lot water that you should seek advice from your plumber that the drainage can deal with it as you don’t want an overflowing shower tray.
Electric showers could be energy efficient because they have an integral pump and instantaneous heat, but don’t forget to make sure that they’re fitted with a qualified electrician.
Heat it up
Check out the heating arrangements inside your new bathroom – many modern radiators will also be created for drying towels and also have the advantage of working off the existing warm water system.
Efficient heating might help disperse condensation however that to satisfy building regulations you will need an extraction system.
Remember to only use a Corgi registered installer in case your heating is gas operated.
Just use a vetted builder
Getting a professional company to change your bathrooms needn’t be a problem. With some 13,000 vetted builders through the UK, the Builders In Kent’s website, www.findabuilder.co.uk is a great place to start, or ask friends and relatives who may have had similar work completed to recommend someone – they’re only likely to achieve this if they had a good experience!
There is a lot to become learnt from experience thats why its important to share your knoweldge. Because of for that Loft Conversion Chingford infomation!